2 - 12 Chapter 2
Chapter 2 - MH240 Setup
2.1.1.7.4 Set the Registrar:
Factory Default: 172.16.0.10 (1.NEC-SETUP)
1. Press 4 (Registrar) to go to the Registrar Edit screen.
2. Edit the Registrar (the IP address of the UX5000 as configured in Program 10-12-
09) and then press the “OK” soft key.
3. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
2.1.1.7.5 Set the Registrar Port:
Factory Default: 5070
1. Press 5 (Registrar Port) to go to the Registrar Port edit screen.
2. Edit the Registrar Port (ex. 5070) and then press the “OK” soft key.
3. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
2.1.1.7.6 Set the User ID: * Optional for MH240 registration *
Factory Default: -
1. Press 6 (User ID) to go to the User ID edit screen.
2. Edit the User ID and then press the “OK” soft key.
3. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
2.1.1.7.7 Set the User Password: * Optional for MH240 registration *
Factory Default: -
1. Press 7 (User Password) to go to the User Password edit screen.
2. Edit the User Password and then press the “OK” soft key.
3. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.