2 - 14 Chapter 2
Chapter 2 - MH240 Setup
2.1.1.9 SIP Advanced Settings * Do Not Change from Default Setting *
✎ The following SIP Advanced Settings should use the default settings unless
told otherwise to change them by NEC Technical Support. Changing these
settings could cause operational/performance issues.
The following program steps are made from the Config menu (see Place the MH240 in Config
Mode (page 2-2)), then enter the Advanced menu within the SIP Setting menu:
1. Go to “Config” menu. (See “PLACE THE MH240 IN CONFIG MODE”)
2. Press 2 (SIP Setting) to view SIP Setting menu.
3. Press
▲
▼
to select a profile you want to edit and then press the “OK” soft key.
4. Press 0 (Advanced) to view the Advanced menu.
Follow the steps in order to define the each of the required options for the MH240 setup.
2.1.1.9.1 Set the Register Timer:
Factory Default: 3600 sec
You can modify the register timer as required.
1. From the Advanced screen, press 1 (Register Timer) and then press the “OK”
soft key.
2. Edit the Register Timer and then press the “OK” soft key.
3. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
2.1.1.9.2 Set the Codec:
Factory Default: 1.Auto
You can set the codec type that is used for the phone as required.
1. Press 2 to go to the Codec screen.
2. Press
▲
▼
to select an appropriate codec and then press the “OK” soft key.
3. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.