2 - 10 Chapter 2
Chapter 2 - MH240 Setup
2.1.1.6.11 Set the SIP Profile:
✎ This option must first be set up within the SIP Setting menu. Refer to SIP
Settings for the MH240 (page 2-11). Once defined, the SIP Profile will be
displayed in this menu list.
Factory Default: NEC-SETUP (1.NEC-SETUP)
2.1.1.6.12 Set the Hand-off List:
Factory Default: NEC-SETUP
1. From the “Network” screen, press 2 (Hand-off List) to view Hand-off List.
2. Press
▲
▼
to select a profile area you want and then press the “OK” soft key.
3. Press
▲
▼
to select a profile you want to add and then press “Save” soft key.
4. Press HOLD as needed to exit back to the Network screen.
5. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
2.1.1.6.13 Set the 1st Connect:
Factory Default: NEC-SETUP
1. From the “Network” screen, press 3 (1st Connect) to view 1st Connect.
2. Press
▲
▼
to select a profile you want to connect first and then press the “OK” soft
key.
3. Press HOLD to exit back to the Config screen.
4. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
To Next Page
Loading...
Need help?
General