2 - 8 Chapter 2
Chapter 2 - MH240 Setup
2.1.1.6.5 Set the DHCP (IP):
✎ Select either DHCP or Fixed for the IP address. For Fixed IP, skip the “Set
the IP Address” steps below.
Factory Default: DHCP
1. Within the desired Profile within the Config menu, at the Profile Setting screen,
press 2 (IP Setting) + 2 (DHCP) to enable DHCP.
2. Press HOLD as needed to exit back to the Profile Setting (Prof. Setting) screen.
3. The Net Mask, Gateway, and DNS features below are for the Fixed IP Address
option only. Continue with the Set the SIP Profile: (page 2-10) feature or press
the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
2.1.1.6.6 Set the Fixed IP Address:
✎ Select either DHCP or Fixed for the IP address. For DHCP, use the “Set the
DHCP (IP)” steps above.
Factory Default: 172.16.1.240 (1.NEC-SETUP)
1. Press 2 (IP Setting) + 1 (Fixed IP) + 1 (IP Address) to go to the IP Address edit
screen.
2. Edit the IP Address corresponding to your network. This address would have to
be given to you by the computer management department along with other
network parameters. Then press the “OK” soft key.
Ex: IP 172.16.1.207 NetMask 255.255.0.0 Gateway 172.16.0.1
DNS does not require an entry.
3. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
4. Press HOLD enough times to get back to Profile Settings menu
2.1.1.6.7 Set the Net Mask:
✎ Required only if the Fixed IP address option is selected above.
For DHCP, skip this step as it is automatically configured.
Factory Default: 255.255.0.0 (1.NEC-SETUP)
1. Press 2 (Net Mask) to go to the Net Mask edit screen.
2. Edit the Net Mask you want and then press the “OK” soft key.
3. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
To Next Page
Loading...
Need help?
General