Chapter 2 - MH240 Setup
Chapter 2 2 - 9
2.1.1.6.8 Set the Gateway:
✎ Required only if the Fixed IP address option is selected above.
For DHCP, skip this step as it is automatically configured.
Factory Default: -
1. Press 3 (Gateway) to go to the Gateway edit screen.
2. Edit the Gateway you want and then press the “OK” soft key.
3. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
2.1.1.6.9 Set the DNS Primary:
✎ Required only if the Fixed IP address option is selected above.
For DHCP, skip this step as it is automatically configured.
Factory Default: -
1. Press 4 (DNS Primary) to go to the DNS Primary edit screen.
2. Edit the DNS Primary you want and then press the “OK” soft key.
3. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
2.1.1.6.10 Set the DNS Secondary:
✎ Required only if the Fixed IP address option is selected above.
For DHCP, skip this step as it is automatically configured.
Factory Default: -
1. Press 5 (DNS Secondary) to go to the DNS Secondary edit screen.
2. Edit the DNS Secondary you want and then press the “OK” soft key.
3. Press HOLD as needed to exit back to the Profile Setting (Prof. Setting) screen.
4. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
To Next Page
Loading...
Need help?
General