Installing the E2860 controller shelf in a cabinet or rack
You must install a set of rails for the E2860 controller shelf in your cabinet or rack, and then slide the
controller shelf onto the rails.
Before you begin
• You have reviewed the Safety Notices document included in the box, and understand the
precautions for moving and installing hardware.
• You have the instructions packaged with the rail kit.
Caution: The appliance weighs approximately 132 lb (60 kg) without drives installed. Four people
or a mechanized lift are required to safely move the appliance.
Caution: To avoid damaging the hardware, never move the appliance if drives are installed. You
must remove all drives before moving the shelf.
Caution: Install hardware from the bottom to the top of the rack or cabinet to prevent the
equipment from tipping over. To ensure that the heaviest equipment is at the bottom of the cabinet
or rack, install the SG6000-CN controller above the E2860 controller shelf.
Attention: If you are installing multiple SG6060 appliances in the same rack, consider installing
all the E2860 controller shelves toward the bottom, and the SG6000-CN controllers toward the top.
Before committing to the installation, verify that the 0.5m optic cables shipped with the SG6060
appliance, or cables that you supply, are long enough for the planned layout.
Steps
1. Carefully follow the instructions for the rail kit to install the rails in your cabinet or rack.
For square hole cabinets, you must first install the provided cage nuts to secure the front and rear
of the shelf with screws.
2. Remove the outer packing box for the appliance. Then, fold down the flaps on the inner box.
3. If you are lifting the appliance by hand, attach the four handles to the sides of the chassis.
Push up on each handle until it clicks into place.
Installing the hardware |
25
To Next Page
Loading...
Need help?
General
