DNS/network and IP address for the controller you removed with the MAC address for the
replacement controller.
Note: If the original controller did not use DHCP for the IP address, the new controller will
adopt the IP address of the controller you removed.
7. Bring the controller online using SANtricity System Manager:
a. Select Hardware.
b. If the graphic shows the drives, select Show back of shelf.
c. Select the controller you want to place online.
d. Select Place Online from the context menu, and confirm that you want to perform the
operation.
e. Verify that the seven-segment display shows a state of 99.
8.
Confirm that the new controller is Optimal, and collect support data.
Related information
E-Series and SANtricity 11.5 Documentation Center
Replacing hardware components in the E2860 controller
shelf
You might need to replace a controller battery, drive, fan, or power supply in the E2860 controller
shelf.
Before you begin
You have the E-Series hardware replacement procedure.
About this task
To replace the battery in the E2800 controller, see the instructions in this guide for replacing an
E2800 controller. Those instructions describe how to remove a controller from the appliance, remove
the battery from the controller, install the battery, and replace the controller.
To replace a drive, power supply, fan, or drive drawer in the E2860 controller shelf, access the E-
Series procedures for maintaining E2800 hardware.
FRU
See E-Series instructions for
Drive Replacing a drive in 60-drive shelves
Power canister Replacing a power canister in 60-drive shelves
Fan canister Replacing a fan canister in 60-drive shelves
Drive drawer Replacing a drive drawer in 60-drive shelves
Related tasks
Replacing an E2800 controller
on page 67
Related information
E-Series and SANtricity 11.5 Documentation Center
72
| Hardware Installation and Maintenance Guide for SG6000 Appliances
To Next Page
Loading...
Need help?
General
