5. When you are satisfied with your selections, click Save.
Note: You might lose your connection if you made changes to the network or link you are
connected through. If you are not reconnected within 1 minute, re-enter the URL for the
StorageGRID Appliance Installer using one of the other IP addresses assigned to the appliance:
http://SG6000-CN_Controller_IP:8080
Related concepts
10/25-GbE port connections for the SG6000-CN controller
on page 16
Configuring StorageGRID Webscale IP addresses
You use the StorageGRID Appliance Installer to configure the IP addresses and routing information
used for the appliance Storage Node on the StorageGRID Webscale Grid, Admin, and Client
Networks.
About this task
You must either assign a static IP for the appliance on each connected network or assign a permanent
lease for the address on the DHCP server.
Note: If the virtual nodes in your grid are deployed on VMware, you must use a static IP address
for the appliance on the Grid Network.
48
| Hardware Installation and Maintenance Guide for SG6000 Appliances
To Next Page
Loading...
Need help?
General
