EasyManuals Logo

NETGEAR D6300 User Manual

NETGEAR D6300
142 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #100 background imageLoading...
Page #100 background image
Advanced Settings
100
D6300 WiFi DSL Modem Router
Wireless Repeater. The WiFi modem router sends all traffic from its local wireless or wired
computers to a remote access point. To configure this mode, you have to know the MAC
address of the remote parent access point.
The D6300 WiFi modem router is always in dual-band concurrent mode,
unless you turn off
one radio. If you enable the wireless repeater in either radio band, the wireless base station
or wireless repeater cannot be enabled in the other radio band. However, if you enable the
wireless base station in either radio band and use the other radio band as a wireless WiFi
modem router or wireless base station, dual-band concurrent mode is not affected.
For you to set up a wireless network with WDS,
the following conditions have to be met for
both access points:
Both access
points have to use the same SSID, wireless channel, and encryption mode.
Both access
points have to be on the same LAN IP subnet. That is, all the access point
LAN IP addresses are in the same network.
All LAN devices (wired and wireless computers) have to be configured to operate in the
same LAN ne
twork address range as the access points.
Wireless Repeating Function
Select ADVANCED > Advanced Setup > Wireless Repeating Function to view or change
wireless repeater settings for the WiFi modem router.
Enable Wireless Repeating Function. Select the check box for the 2.4-GHz or 5-GHz
network to use the wireless repeating function.
Disable Wirel
ess Client Association. If your WiFi modem router is the repeater,
selecting this check box means that wireless clients cannot associate with it. Only LAN
client associations are allowed.
- If you are setting up
a point-to-point bridge, select this check box.

Table of Contents

Other manuals for NETGEAR D6300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR D6300 and is the answer not in the manual?

NETGEAR D6300 Specifications

General IconGeneral
Ethernet LANYes
Cabling technology10/100/1000Base-T(X)
Networking standardsIEEE 802.11ac
Ethernet LAN data rates10, 100, 1000 Mbit/s
Ethernet LAN interface typeGigabit Ethernet
Wi-Fi bandDual-band (2.4 GHz / 5 GHz)
Wi-Fi standards802.11a, 802.11b, 802.11g
Channels quantity2 channels
Top Wi-Fi standardWi-Fi 4 (802.11n)
WLAN data transfer rate (max)300 Mbit/s
Bandwidth2.4 GHz
Rack mounting-
Frequency range2.4 - 5 GHz
USB ports quantity2
Minimum system requirementsInternet Explorer 5.0, Firefox 2.0, Safari 1.4, Google Chrome 11.0
RJ-11 ports quantity1
Ethernet LAN (RJ-45) ports4
Security algorithmsWPA, WPA2, WPA2-PSK, WPS
Product colorBlack
Flash memory128 MB
CertificationRoHS, CEC, WEEE, Wi-Fi
Cables includedLAN (RJ-45), Phone (RJ-11)
Weight and Dimensions IconWeight and Dimensions
Depth255 mm
Width205 mm
Height77 mm
Weight654 g

Related product manuals