NETGEAR MS510TX - Change an Access Rule

Manage Device Security
237
Smart Managed Pro Switches MS510TX and MS510TXPP
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > Access > Access Control > Access Rule Configuration.
The Access Rule Configuration page displays.
6. From the Rule Type menu, select Permit or Deny to permit or deny access when the
selected rules are matched.
A Permit rule allows access by traffic that matches the rule criteria. A Deny rule blocks
traffic that matches the rule criteria.
7. From the Service Type menu, select the access method to which the rule is applied.
The policy is restricted by the selected access method. Possible access methods are
HTTP, Secure HTTP (SSL), and SNMP.
8. In the Source IP Address field, enter the source IP address of the client originating the
management traffic.
9. In the Mask field, specify the subnet mask of the client that originates the management
traffic.
10. In the Priority field, assign a priority to the rule.
The rules are validated against the incoming management request in ascending order of
their priorities. If a rule matches, the action is performed and subsequent rules below that
are ignored. For example, if a source IP 10.10.10.10 is configured with priority 1 to
permit, and source IP 10.10.10.10 is configured with priority 2 to deny, then access is
permitted if the profile is active, and the second rule is ignored.
11. Click the Add button.
The access rule is added.
Change an Access Rule
You can change an access rule only when the associated access profile is in a deactivated
state (see Activate or Deactivate an Access Control Profile and View the Profile Summary on
page 239).
 To change an access rule for an access profile:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 12.