Enable or disable IP passthrough
Depending on how you use your mobile hotspot, you might want to enable IP
passthrough. When IP passthrough is enabled, your mobile hotspot takes the IP address
that your cellular service provider assigned to your device and passes it through to a
connected device. Enabling IP passthrough allows you to configure the LTE subnet
mask from the web user interface, which might be necessary for some use cases.
To enable or disable Ethernet:
1. Quickly press and release the Power button to wake your mobile hotspot.
The lock screen displays.
2. Swipe up to unlock your mobile hotspot.
The home screen displays.
3. Tap Settings > Mobile > Roaming Data.
The Roaming Data page displays.
4. Tap the ON or OFF icon.
Your mobile hotspot asks you to confirm that it must restart to enable or disable IP
passthrough.
5. Tap Continue.
Your mobile hotspot restarts with IP passthrough enabled or disabled.
Perform a factory reset
In some cases, you might want to reset your mobile hotspot to factory settings.
Performing a factory reset clears all settings from your mobile hotspot and initiates the
first-time setup process.
To perform a factory reset:
1. Quickly press and release the Power button to wake your mobile hotspot.
The lock screen displays.
2. Swipe up to unlock your mobile hotspot.
The home screen displays.
3. Tap Settings > More > Factory Reset.
The Factory Reset page displays.
4. Tap Reset Now.
User Manual51Adjust network, security, and
performance settings
Nighthawk M6 Pro, Nighthawk M6
To Next Page
Loading...
Need help?
General
Weight and Dimensions
