NETGEAR Nighthawk M6 Pro

Disable or re-enable the DHCP
server feature from the web user
interface
By default, your mobile hotspot acts as a DHCP server. The server assigns IP, DNS server,
and default gateway addresses to all computers connected to the LAN. The assigned
default gateway address is the LAN address of the router.
You can use another device on your network as the DHCP server, or specify the network
settings of all your computers.
To disable or re-enable the DHCP server feature from the web user interface:
1. From the web user interface dashboard, select Settings > Advanced > Mobile
Router Setup.
The Mobile Router Setup page displays.
2. Clear the Use mobile router as DHCP server check box to disable the DHCP server
feature, or select the check box to re-enable it.
3. Click or tap Apply.
A message displays telling you that to save this change, your device must restart.
4. Click or tap Continue.
Your settings are saved.
View data usage from the web user
interface
To view data usage from the web user interface:
1. From the web user interface dashboard, click or tap See data usage, or select
Settings > Advanced > Data Usage.
The Data Usage page displays.
2. (Optional) To reset the data usage counter, click or tap Reset.
The counter is reset.
User Manual70Access the web user interface
Nighthawk M6 Pro, Nighthawk M6