NETGEAR Nighthawk M6 Pro User Manual

The APN page displays.
3. Specify the APN name.
The APN name is a label for display in the UI.
4. Specify the APN.
This step specifies the APN as defined by the carrier.
5. Change the PDP (data protocol), if necessary:
•
IPV4
•
IPV6
•
IPV4V6
6. Change the PDP roaming protocol, if necessary:
•
None
•
IPV4
•
IPV6
•
IPV4V6
NOTE: PDP roaming protocol is the IP protocol used while you are roaming
(for example when you are traveling and the roaming network does not
support IPv6).
7. Select the network authentication mode:
•
None
•
PAP
•
CHAP
•
PAPCHAP
8. Enter the name and password, if they are required for the network.
9. Click or tap Add.
The entry is added to the table.
Select an APN to use
To select an APN to use:
1. From the web user interface dashboard, select Settings > Advanced > Cellular.
The Cellular page displays.
2. Select the Active radio button next to the APN entry.
The APN is selected.
User Manual72Access the web user interface
Nighthawk M6 Pro, Nighthawk M6

NETGEAR Nighthawk M6 Pro Specifications

General

DSL WAN	No
Ethernet WAN	Yes
3G/4G USB modem compatibility	-
Ethernet LAN (RJ-45) ports	1
Battery capacity	5040 mAh
Power source type	Battery, USB
Ethernet LAN data rates	10, 100, 1000, 2500 Mbit/s
Ethernet LAN interface type	Ethernet
Wi-Fi band	Tri-band (2.4 GHz / 5 GHz / 6 GHz)
Top Wi-Fi standard	Wi-Fi 6E (802.11ax)
WLAN data transfer rate (max)	3600 Mbit/s
Cables included	USB Type-C
Antenna connector type	TS9
Product type	Portable router
Product color	Black
4G standard	LTE
4G LTE category	20
Processor model	Qualcomm Snapdragon X65
Processor manufacturer	Qualcomm

Weight and Dimensions

Width	105 mm
Height	21.5 mm
Weight	256 g