NETGEAR ProSafe FVS114 User Manual

Advanced Configuration 8-1
202-10098-01, April 2005
Chapter 8
Advanced Configuration
This chapter describes how to configure the advanced features of your FVS114 ProSafe VPN
Firewall. These features can be found under the Advanced heading in the main menu of the
browser interface.
WAN Setup
Using the WAN Setup page, you can set up a Default DMZ Server and allow the router to respond
to a 'ping' from the internet. Both of these options have security issues, so use them carefully.
Figure 8-1: WAN Setup menu
• Connect Automatically, as Required: Normally, this option should be enabled. An Internet
connection will be made automatically after each timeout, whenever Internet-bound traffic is
detected. This provides connection on demand and is potentially cost-saving.
If disabled, you must connect manually, using the "WAN Status" button on the Router
Maintenance/Router Status screen. This manual connection will stay up all the time without
timeouts.

NETGEAR ProSafe FVS114 Specifications

General

VPN Support	Yes
Number of Ports	4
Power Supply	12V DC, 1A
VPN tunnels	Up to 5
Protocols	IPSec, PPTP
Port Speed	10/100 Mbps
DoS/DDoS Protection	Yes
URL Filtering	Yes
Weight	1.5 lbs
Firewall features	Stateful Packet Inspection
Firewall Type	Stateful Packet Inspection (SPI)
Interfaces	4 x 10/100 Mbps Ethernet ports, 1 x 10/100 Mbps WAN port