NETGEAR ProSafe FVS114 User Manual

Reference Manual for the ProSafe VPN Firewall FVS114
7-8 Maintenance
202-10098-01, April 2005
To restore the factory default configuration settings without knowing the login password or IP
address, you must use the reset button on the rear panel of the firewall. See “Restoring the Default
Configuration and Password” on page 9-7.
Changing the Administrator Password
The default password for the firewall’s Web Configuration Manager is password. NETGEAR
recommends that you change this password to a more secure password.
From the main menu of the browser interface, under the Maintenance heading, select Set Password
to bring up this menu.
Figure 7-7: Set Password menu
To change the password, first enter the old password, and then enter the new password twice. Click
Apply. To change the login idle timeout, change the number of minutes and click Apply.
Diagnostics
You can use the Diagnostics page to perform various diagnostics. For normal operation, these are
not required.
From the main menu of the browser interface, under the Maintenance heading, select Diagnostics
to bring up this menu.

NETGEAR ProSafe FVS114 Specifications

General

Brand	NETGEAR
Model	ProSafe FVS114
Category	Firewall
Language	English