Reference Manual for the ProSafe VPN Firewall FVS114
5-28 Basic Virtual Private Networking
202-10098-01, April 2005
a.
Establish an Internet connection from the PC.
b. On the Windows taskbar, click the Start button, and then click Run.
c. Type ping -t 192.168.3.1 and then click OK.
Figure 5-34: Running a Ping test to the LAN from the PC
This will cause a continuous ping to be sent to the first FVS114. Within two minutes, the
ping response should change from “timed out” to “reply.”
Note: Use Ctrl-C to stop the pinging.
Figure 5-35: Ping test results
Once the connection is established, you can open the browser of the PC and enter the LAN IP
address of the remote FVS114. After a short wait, you should see the login screen of the VPN
Firewall (unless another PC already has the FVS114 management interface open).
• Gateway-to-Gateway Configuration—test the VPN tunnel by pinging the remote network
from a PC attached to the FVS114.
a. Open a command prompt (Start -> Run -> cmd).
b. Type ping 192.168.3.1.
To Next Page
Loading...
