Stora Hardware
15
NETGEAR Stora
LED and Connector Descriptions
The following table describes the function of Stora hardware components:
Item Description
Power
button
• Turn on Stora. Press once.
• Turn off Stora. To correctly shut down your Stora, press and hold the
Power button for about 5 seconds. The blue light on the front panel blinks
before shutting off. If the unit is hung, press and hold the Power button to
force shutdown.
NOTE: To save power, your Stora automatically goes into disk spin down
mode when not used for 12 minutes.
Power
LED
• Solid blue. Power is on.
• Blinking blue. The Stora is booting up or shutting down.
• Not illuminated. The system is powered off.
Disk 1:
Top
LED
Disk 2:
Bottom
LED
• On. Disk is installed.
• Solid green. Drive is operating normally.
• Blinking green. Stora is booting up or shutting down. Also indicates
activity such as copying data.
• Solid amber. Drive is not ready; however, if the LED is solid amber
constantly, it indicates a problem with the drive. Try one or more of the
following troubleshooting tips:
- Check that cables are securely connected and power is on.
- Remove and then reinsert the disk.
- Turn off Stora and turn it on again to reboot the system.
• Not illuminated. No disk is installed.
USB port
Connect a USB drive and printer.
Ethernet
port and
LED
Ethernet connection LEDs:
• Solid amber. Indicates a 10/100M connection.
• Solid green.Indicates a 1G connection.
• Blinking green or amber. Indicates link activity.
Power
cable
socket
Plug the power cable into the Stora system.
Reset
button
Insert a paper clip or pen to reset Stora to its original factory default settings.
Can also be used when changing your password.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
