NETGEAR VEVG2610-1FXAUS

Internet Setup
24
Dual Band Wireless VDSL2 + Ethernet Gateway
• Router’s IPv6 Address on WAN. This field shows the IPv6 address that is acquired
for the gateway’s WAN (or Internet) interface. The number after the slash (/) is the
length of the prefix, which is also indicated by the underline (_) under the IPv6
address. If no address is acquired, the field displays Not Available.
• Router
’s IPv6 Address on LAN.
This field shows the IPv6 address that is acquired
for the gateway’s LAN interface. The number after the slash (/) is the length of the
prefix, which is also indicated by the underline (_) under the IPv6 address. If no
address is acquired, the field displays Not Available.
6. (Optional) In the DHCP User Class (If Required) field, enter a host name.
Most people can leave this field blank, but if your ISP has given you a specific host name,
enter it here.
7. (Optional) In the DHCP Domain Name (If Required) field, enter a domain name.
You can type the domain name of your IPv6 ISP. Do not enter the domain name for the
IPv4 ISP here. For example, if your ISP’s mail server is mail.xxx.yyy
.zzz, type xxx.yyy.zzz
as the domain name. If your ISP provided a domain name, type it in this field. For
example, Earthlink Cable might require a host name of home, and Comcast sometimes
supplies a domain name.
8. Select an IP
Address
Assignment radio button.
• Use DHCP Server. This method passes more information to LAN devices, but some
IPv6 systems might not support the DHCv6 client function.
• Auto Config
. This is the default setting.
This setting specifies how the gateway assigns IPv6 addresses to the devices on your
home network (the LAN).
9. (Optional) Select the Use This Interface ID check box and specify the interface ID that you
want to be used for the IPv6 address of the gateway’s LAN interface.
If you do not specify an ID here, the gateway generates one automatically from its MAC
address.
10. Click the Apply
button.
Your settings are saved.
Set Up an IPv6 6to4 Tunnel Internet Connection
The remote relay gateway is the gateway to which your gateway creates a 6to4 tunnel. Make
sure that the IPv4 Internet connection is working before you apply the 6to4 tunnel settings for
the IPv6 connection.
 To set up an IPv6 Internet connection by using a 6to4 tunnel:
1. Launch an Internet browser from a computer or wireless device that is connected to the
network.
2. T
ype http://www
.routerlogin.net or http://www.routerlogin.com.
A login screen displays.