Specify Network Settings
71
Dual Band Wireless VDSL2 + Ethernet Gateway
The BASIC Home screen displays.
4. Select Advanced > Setup > LAN Setup.
5. In the IP Address field, type the IP address.
6. In the IP Subnet Mask field, type the subnet mask of the gateway.
The IP address and subnet mask identify which addresses are local to a specific device
and which must be reached through a gateway or gateway.
7. Click the Apply button.
Your changes are saved.
If you changed the LAN IP address of the gateway, you are disconnected when this
change takes ef
fect.
To reconnect, close your browser
, relaunch it, and log in to the gateway.
Specify the IP Addresses That the Gateway Assigns
By default, the gateway acts as a Dynamic Host Configuration Protocol (DHCP) server. The
gateway assigns IP, DNS server, and default gateway addresses to all computers connected
to the LAN. The assigned default gateway address is the LAN address of the gateway.
These addresses must be part of the same IP address subnet as the gateway’s LAN IP
address. Using the default addressing scheme, define a range between 198.168.0.2 and
192.168.0.254, although you can save part of the range for devices with fixed addresses.
The gateway delivers the following parameters to any LAN device that requests DHCP:
• An IP address from the range that you defined
• Subnet mask
• Gateway IP address (the gateway’
s LAN IP address)
To Next Page
Loading...
