Hardware Setup
9
Dual Band Wireless VDSL2 + Ethernet Gateway
You can use the LEDs to verify status and connections. The following table lists and
describes each LED and button on the front panel of the gateway.
Table 1. LED and button descriptions
LEDs and
Buttons
Description
Connect (WPS)
button
Pressing this button opens a two-minute window when you can use WPS on computers or
wireless devices to connect to the gateway’s WiFi network without typing the WiFi
password. The LED blinks during the two-minute window.
Internet
• Solid blue. The gateway is connected to the Internet.
• Solid red. PPP is in progress.
• Blinking red. DSL synch is in process.
WiFi
• Solid blue. The WiFi radio is on.
• Off. The wireless radio is turned off and you cannot connect to the gateway with WiFi.
iQ Connected
• Solid blue. STB is connected with WiFi or Ethernet.
• Off. STB is not connected.
To Next Page
Loading...
