NETGEAR Wireless-N Access Point WN802T v2 Reference Manual
Advanced Wireless Bridging 5-3
v1.0, September 2008
7. Enter the MAC (physical) address of the other bridge mode wireless access point in the
Remote MAC Address field.
8. Under Authentication Settings, select one of the network authentication types from the
Network Authentication drop-down menu (one of the supported types—WEP, WPA-PSK, or
WPA2-PSK should be used to protect the communication).
9. Select encryption strength from the Data Encryption options available.
10. Click Apply.
11. You are taken back to the Wireless Bridge Settings screen (Figure 5-1) with the new profile
information. Enable the profile now if you wish to.
You can add more wireless access points in the same way for a total of six (these wireless
access points must be configured for Multi-Point Bridging).
12. Click Apply to save your changes.
Figure 5-2 Edit security profile
To Next Page
Loading...
