*Disable Discrete 2 of 5
Set Lengths for Discrete 2 of 5
The length of a code refers to the number of characters (i.e., human readable characters), including check
digit(s) the code contains. Lengths for D 2 of 5 may be set for any length, one or two discrete lengths, or
lengths within a specific range.
One Discrete Length
Select this option to decode only those codes containing a selected length. For example, select D 2 of 5 One
Discrete Length, then scan 1, 4, to decode only D 2 of 5 symbols containing 14 characters. Numeric Bar Codes
is in appendix. To change the selection or cancel an incorrect entry, scan Cancel in appendix.
D 2 of 5 - One Discrete Length
Two Discrete Lengths
Select this option to decode only those codes containing two selected lengths. For example, select D 2 of 5 Two
Discrete Lengths, then scan 0, 2, 1, 4, to decode only D 2 of 5 symbols containing 2 or 14 characters. Numeric Bar
Codes is in appendix. To change the selection or cancel an incorrect entry, scan Cancel in appendix
D 2 of 5 - Two Discrete Lengths
Length Within Range
Select this option to decode codes within a specified range. For example, to decode D 2 of 5 symbols containing
between 4 and 12 characters, first scan D 2 of 5 Length Within Range, then scan 0, 4, 1 and 2 (single digit numbers
must be preceded by a leading zero). Numeric Bar Codes is in appendix. To change the selection or cancel an
incorrect entry, scan Cancel in appendix.
D 2 of 5 - Length Within Range
To Next Page
Loading...
Need help?
General
