7 MAINTENANCE
PAGE
7.2R
Revision: Date Name Signed
Substitute for issue issued
23.06.03
Mangel
of approved
24.06.03
Denk
text no. 30100
released
24.06.03
Denk
copy to: 95
Lubricating Oil:
GB
Industrial Designation
Permitted Product
application
DIN 51502
Food and Authorized
CLP HC
"KLÜBER" KLÜBEROIL 4 UH 1 - 460
Beverage for use
460
authorized under USDA H1
Industry in foodstuffs
only
This synthetic oil meets both the German
"Arzneimittelbuch" requirements and the still stricter
US American FDA regulations.
Nevertheless, it is not quite harmless if swallowed
in more than minor quantities!
At a sudden break in a joint up to 450 ml of lubricating oil together with
metal rubbings may enter the pumping medium. It is therefore of essential
importance to regularly check the state of the joint seals and renew in time,
if necessary.
If the pin joints operate without lubricating oil or seals, there will be no risk
of contaminating the medium with oil. This operation, however, results in a
higher amount of rubbed off metal parts through wear on the joints. These
metal rubbings will inevitably and continuously come into contact with the
pumping medium.
CLP
460
"SHELL" Omala 460
General
Industry with SM-pin joint seal
(8235) of EPDM prescribed:
KLÜBERSYNTH
GH 6-320
CLP PG
320
To Next Page
Loading...
