Continued Page 1.1R
N
E
M
O
P
U
M
P
E
N
1 SAFETY PRECAUTIONS
PAGE
1.1
Date Name Signed Revision: 6
issued 16.06.03 Mangel Substitute for issue
approved 17.06.03 Denk of 07.10.96
released 17.06.03 Denk
text no. 30100
copy to: 95
▲ Danger to personnel from electricity,
machinery and chemicals
▲ Danger to the environment from
leakage of hazardous substances.
1.4 Safety Conscious Working
In addition to the safety instructions listed in
the manual, it is essential to observe the
national accident prevention directives
currently in force and any of the users own
internal regulations concerning work and
safety.
1.5 Safety Instructions
for the User / Operator
▲ If there is a risk of danger from any hot
or cold machine component, the user
must fit protective guards to prevent
such components from being touched
(according to Standard EN 563).
▲ Protective guards fitted to prevent
contact with moving parts (eg.
couplings) must be in position when
the machine / equipment is in use.
▲ Leakages (eg. from a shaft seal) of
hazardous materials (eg. explosive,
toxic, hot material) must be
discharged in such a way that
neither personnel nor the
environment are placed at risk.
Legal directives must be observed.
▲ All possible danger from electricity must
be eliminated (for details see eg. the
regulations of your local power supply
company).
1.6 Safety Instructions for
Maintenance, Inspection
and Installation
The user must ensure that all maintenance,
inspection and installation work is carried out
by authorized and qualified personnel who
understand the operating instructions and
are adequately trained.
Work on a pump / equipment must only be
carried out with the machine stopped and
electrical power supply turned off. The pump/
equipment must not be under any pressure
and must have cooled off. All procedures
detailed in these operating instructions on
the stoppage of the machine must always be
adhered to.
Pumps / equipment which convey harmful
media must be decontaminated.
Immediately after the maintenance work is
finished all safety devices and guards must be
re-installed and the safety trips must be
tested.
Before putting the machine back into opera-
tion the points detailed in section "Start-up"
should be observed.
GB
To Next Page
Loading...