Newall C80 - Special Functions; Mill Special Functions Overview; Lathe Special Functions Overview; Generic Special Functions Overview

Special functions
7-1
N
Special functions
This chapter describes the C80’s special functions.
In addition to the Standard Functions described on page 6-1,
the C80 has a number of inbuilt Special Functions, that you
access using the [F1], [F2] and [F2
+
] keys.
Most Special Functions work specifically in the Mill or Lathe
modes, but the Generic functions can work with either.
Most Special Functions require only one function key to
operate. You can allocate them to either [F1] or [F2].
The functions marked [F2] require two function keys. You can
only allocate these to [F2] and [F2
+
].
The Generic option also includes all the Mill and Lathe Special
Functions.
Each of the Special Functions listed here is described in detail
later in the Mill functions, Lathe functions and Generic functions
chapters.
Mill functions
The Special Functions in Mill mode are:
Lathe functions
The Special Functions in Lathe mode are
Generic functions
The Special Functions in Generic mode are
Special Function Display
Bolt Hole Circle bOLt HOL
Arc ArC
Line Hole LinE
Polar Coordinates PoLAr
Special Function Display
Tool Offsets tool F2
Taper taper
Summing su m
Vector Vector
Special Function Display
Sub Datum and Job Numbers Sd m F2
Special Function Display