Vectoring
9-5
N
Setting the parameters
You select the axes to be added together in Setup Mode.
To enter Setup Mode:
1. Leave any Special Function that is running
2. Press [set up].
The centre display shows ‘set Up’.
3. Press the up or down navigation key to choose
‘addition’.
4. Press the left or right navigation key to choose which axes
are to be added: X+Z’ or Z+Z’.
5. Press the up or down navigation key to choose ‘store’.
6. Press [ent] to store the change.
Using the summing function
Press [F1] or [F2] to turn the function on.
Press [F1] or [F2] to turn the function off.
For X + Z’
The X display shows the Sum of the two selected axes and the
axis identifier shows ‘s’.
The Z display shows the Z axis as normal.
The Z’ display shows the Z’ axis as normal.
For Z + Z’
The X display shows the X as normal.
The Z display shows the Sum of the two selected axes and the
axis identifier shows ‘s’.
The Z’ display shows the Z’ axis as normal.
You can zero or preset any of the axes in the usual way.The
Sum display alters to take account of the new value.
You may need to change the direction of Z’ in Setup to ensure
that the axes sum and not subtract.
Vectoring
You use this function to combine the movement of the X and Z
axes with the angle of the compound. Vectoring is only available
on 3 axis units.
The Vectoring function is useful when the compound is set at
an angle. If the compound is set to align with either the X or the
Z axes, see Summing on page 9-4.
To Next Page
Loading...
