Line hole
8-5
N
17. Press the right navigation key to finish setting the
parameters.
The function display shows ‘01’.
Machining the arc
The two axis displays for the selected plane now show the
distance to the Arc starting point.
1. To position the tool ready for machining the arc, (starting
point) move the axes until both displays read zero.
The function display shows the number of the hole to be
machined.
2. Press the left or right navigation key to move between the
positions.
3. When the Arc machining is complete, press [F1] or [F2] to
turn the function off.
If you make a mistake while entering a number, you can press
[ce] to clear the entry one character at a time.
Once you have pressed [ent] to complete an entry, you can
press the left and right navigation keys to move backwards and
forwards one step at a time.
If you enter a Starting Point or Ending Point that is
inconsistent with the Centre and Radius settings, then the
Centre and Radius settings override the inconsistent settings.
The axis that is not involved in the Arc function reads as normal.
You must machine the arc progressively. You cannot jump
between points on the arc.
You should move away from the line of the Arc between points to
avoid over cutting.
Line hole
This function calculates the locations of the holes, given the
following parameters:
1. Plane (X,Y; X,Z or Y,Z)
2. Starting Point
3. Line Length
4. Number of Holes (up to 99)
5. Line Angle
The axis that is not involved in the line hole function reads as
normal.
To Next Page
Loading...
