Newall C80 - Page 36

Mill functions
8-4
N
Setting the parameters
1. Press [F1] or [F2] to turn the function on.
(For three axis units only)
The function display shows ‘p’, and the axis displays show
the Plane in which the holes are to be machined.
2. Press the up or down navigation key to cycle through the
three settings X,Y; X,Z and Y,Z.
3. Press the right navigation key to move to the next step.
The function display shows ‘C’, and the axis displays show
the coordinates of the Arc Centre.
4. Press the Select Key next to the ‘X’, ‘Y’ or ‘z’, to edit each
value as required.
5. Press the right navigation key to move to the next step.
The function display shows ‘r’, and the top display shows
the Arc Radius.
6. Enter a new value if required.
For example: Press [2] [.] [7] [ent] to enter an arc radius of
2.7.
7. Press the right navigation key to move to the next step.
The function display shows ‘st’, and the axis displays
show the coordinates of the Starting Point.
8. Press the Select Key next to the ‘X’, ‘Y’ or ‘z’, to edit each
value as required.
9. Press the right navigation key to move to the next step.
The function display shows ‘end’, and the axis displays
show the coordinates of the Ending Point.
10. Press the Select Key next to the ‘
X’, ‘Y’ or ‘z’ to edit each
value as required.
11. Press the right navigation key to move to the next step.
The function display shows ‘td’, and the top display shows
the Tool Diameter.
12. Enter a new value if required.
For example: Press [.] [5] [ent] to enter a diameter of 0.5.
13. Press the right navigation key to move to the next step.
The function display shows ‘Ie’, and the top axis display
shows whether the cut is to be machined to the internal or
the external radius of the arc.The display shows Internal
‘rad-tOOl’ or External ‘rad tOOl’.
14. Press the up or down navigation key to cycle through the
settings.
15. Press the right navigation key to move to the next step.
The function display shows ‘Cut’, and the top display
shows the Maximum Cut.
16. Enter a new value if required.
For example: Press [.] [1] [5] [ent] to enter a maximum cut
of 0.15.