Generic functions
10-4
N
The display changes to:
‘insert’
‘job’.
For a start job marker
1. Press [ent] to confirm.
The display changes to ‘Job no.’.
2. Enter the number of the Job that you want to add.
For example: Press [1] [ent] to insert the marker for Start
Job 1.
All the following Sub-Datum numbers are incremented by one,
and the display shows the new Start Job marker.
For an end job marker
1. Press the up or down navigation key.
The display changes to ‘end jOb’.
2. Press [ent] to confirm.
All the following Sub-Datum numbers are incremented by one,
and the display shows the new End Job marker.
Deleting a job marker
1. Go to the Job marker that you want to delete.
2. Press [del].
The display shows ‘del sub’.
3. Press the Select Key next to the ‘s’.
Pressing any other key cancels the operation.
All the following Sub-Datum numbers are decremented by one,
and the display shows the next Sub-Datum.
Finding a job
1. Press [F2].
The display shows:
‘sub dat’
‘Job no.’.
2. Press the Select Key next to the ‘J’.
The display changes to ‘Job no.’.
3. Enter the number of the Job that you want to find.
For example: Press [2] [ent] to find Job 2.
If you enter an invalid Job number, the display shows Job 1.
4. Press the up or down navigation key to choose a valid job
number.
5. Press [ent] to continue.
The display shows the Start Job marker.
Once the function is on, you can go from one Sub-Datum to
another, by either of these two methods:
Press [F2], then the Select Key by the ‘S’. Enter the number of
the Sub-Datum that you want to go to.
To Next Page
Loading...
