OPRHT70 A0310
3-3
Set up and Pre-use Preparation
Using the Power Switch
The momentary-type power switch is located on the rear, right side of
the ventilator along the bottom edge.
To power the ventilator On: Press
the power switch once and wait for
the startup screen to appear.
The ventilator will be in a standby
condition. You can make setting
changes and perform the Circuit
Check prior to ventilation.
To start ventilation, press the ‘Start
Ventilation’ button at the top of the
screen.
To power the ventilator Off: Press
the power switch once. A message
appears that prompts you to ‘Press
Accept to Shutdown or Cancel
to Ignore’. Pressing the Accept
button will power off the ventilator.
Pressing Cancel will return the
ventilator to its previous state.
Press Alarm Silence to silence the
Shut Down alarm.
Make Parameter Changes
Most parameters are changed with a simple Touch / Adjust / Accept
method:
1.
Activate the control by touching it (button will appear highlighted).
2. Use the Up/Down s t button to adjust the settings.
3. Press the Accept button to accept the change.
You can make several adjustments before accepting the changes.
When you are satisfied with all of the changes, you can accept them
all by pressing the Accept button once.
Before you accept any change, if you want to go back to the previous
settings, simply press the Cancel button.
3
To Next Page
Loading...