Newport HT70 - Connect Optional Accessories

OPR360U A0509
5-1
5
OPR360U A0509
5-1
5
OPR360U A0509
5-1
5
OPR360U A0509
5-1
5
OPRHT70 A0310
3-9
Set up and Pre-use Preparation
ncla eC
ceA c pt
G SA
UO T PUT
HX
E.
V L A
EV
POX.
R
LI
NE
Figure 7
3
10. Attach the other end of the exhalation valve tubing to the
connector on the exhalation valve.
See Figure 7 for completed setup for HME.
11. Perform the Circuit Check. If the circuit includes an end cap,
retain it for use in the Circuit Check. See Section 5 for
instructions.
Connect Optional Accessories
Connect optional accessories such as the Air/Oxygen Mixer*, Low
Flow Oxygen Blending Bag or Biofilter, to the right side of the HT70 at
the Fresh Gas Intake Port.
The D.C. Auto Lighter Cable connects into the power adapter
connector on the rear of the Power Pac battery pack.
WARNING Do not block the Fresh Gas Intake Port on the right side
of HT70. Use only approved accessories.
*Call for availability