A
PPrrooggrraamm
is a range of scenes (max 48) performed in succession.
To create/modify a program follow all steps listed below:
1) If Matrix is switched off, switch it on pressing
POWER
key.
2) Press Program key to activate the
PROGRAM
function.
(the Program led key will light up).
3) Press 1÷12 keys to select only the program that you want to modify.
(only one program
hhiigghhlliigghhtteedd
).
For successive program use the
PPAAGGEE
key
4) Press the UNITS key and select through the 1÷12 keys the units that must
work in the program. Confirm with the DONE key
5) Press Scene key to activate the
SCENE
function.
(the Scene led key will light up).
6)
Press one of the 1÷12 keys to select the scene that we want to create/modify
.
For successive scenes use the
PPAAGGEE
key
7) Press the EDIT key to create/modify the selected scene.
8) Modify the position with the joystick and the sets of the channels with the
relative faders, press
UNIT
key for
next/precedent
unit.
9) When the scene has been completed, it can be stored through the SAVE key.
11)
Now
Matrix
is in the next scene
repeat again the 7 and 8 steps.
12)
When
the creation of the scenes has been finished press Program key to
come back to the
PROGRAM
function.
(the Program led key will light up).
13) Finally you must press the LIVE key followed to GO key to execute the pro-
gram.
The program is complete; to create/modify others repeat again all the above
steps.
9.1 CREATION OF A PROGRAM
GB
To Next Page
Loading...
