Next Matrix Live - Page 43

A
CChhaassee
is a play of lights, it is a sequence of steps (from 1 to 48 max).
To create/modify a program follow all steps listed below:
1) If Matrix is switched off, switch it on pressing
POWER key.
2) Press Chase key to activate the
CHASE function.
(the Chase led key will light up).
3) Press 1÷12 keys to select only the chase that you want to modify.
(only one chase
hhiigghhlliigghhtteedd
).
For successive chase use the
PPAAGGEE
key
4) Press STEPS key to activate the STEPS function
5)
Press one of the 1÷12 keys to select the step that we want to create/modify .
For successive steps use the
PPAAGGEE
key
7 Press the EDIT key to create/modify the selected step .
9) Modify the value of the channels through the 12 relative faders or the 1÷12 keys.
For next channels use the
PPAAGGEE
key
10) When the step is completed it can be stored through the SAVE key.
11) Now Matrix is in the next step repeat again the 9 and 10 steps .
12) When the creation of the steps has been finished press Chase key to
come back to the CHASE function.
(the Chase led key will light up).
13) Finally you must press the LIVE key followed to GO key to execute the
chase.
The chase is complete; to create/modify others repeat again all the above
steps.
9.2 CREATION OF A CHASE
GB