Next Matrix Live - Page 51

10.8 FUNCTION KEYS IN EDIT DMX PATCH MODE
GB
In EDIT DMX PATCH mode there are 6
ffuunnccttiioonn kkeeyyss
see ( Fig. 51 par
1100..77
).
COPY Key :
Pressing this key on the display shows
"" SSEELLEECCTT DDEESSTTIINNAATTIIOONN UUNNIITT"",,
select through the
1÷12 keys the destination of the copy.
For the successive unit use
PPAAGGEE
key
LOAD Key :
Press this key to load compleate setup from library, see par
1100..99
.
EDIT Key :
Press this key to modify the name of each channel and its parameters , see par
1100..1111
.
ERASE Key :
Press this key to the erase active unit, select through the 1÷12 keys (for the successive
units use
PPAAGGEE
key) the unit that must be erased, then press the
EERRAASSEE
key.
The unit will erased in a permanent way, it is not possible recover it.
PATCH Key :
Press this key to modify start address of the unit , use the fader under PATCH write or
the encoder. To confirm the modify press the
OOKK
key, to get out of the function press
the
EESSCC
key
.
Matrix will calculate the last channel for that unit and under PATCH write you can shows
the configuration to set on the dip-switch of the unit.
NOTE: ANY BUILDERS ADOPT THE CONFIGURATION OF THE DIP-SWITCH LIKE
STANDARD SET TO "0" FOR INDICATE DMX CHANNEL "1." IN THIS CASE FOR A
CORRECT OPERATION, YOU MUST BE ADDED +1" (EXAMPLE ADDRESS OF
UNIT START = 128 ---> MATRIX ADDRESS = 129
The on position of the dip-switch is with white box appears aloft.
When you exit from the menù the software controls if there are unit with equal or overlap-
ped addresses, the display shows a message of error "PATCH OVERLAY AT UNIT."
AUTO
Key :
Press this key to modify start address in automatic way , select through the 1÷12 keys
the unit of start , then press the
AUTO key.
For the successive unit use
PPAAGGEE
key
Now from the unit of start to the last unit the addresses have been assigned.
For the successive unit use
PPAAGGEE
key