GPS NAVIGATOR
Then enter the CONFIG set-up on "your" instrument and set it to MASTER. Turn the
power OFF and then ON again to activate this change. The waypoints are now used
from the new MASTER instead. Both (or all) instruments can now use the "new"
waypoint bank.
9.2 EXTRA FEATURES WITH SILVA NEXUS NETWORK
Integrate the navigator with the NEXUS Multi Control and Server by adding compass
and speed transducers. You will then get compass heading, boat speed, drift and tidal
data (its speed and direction).
PC-INTERFACE CABLE
The interface, (RS 232 to RS 485) is built-in in the 25-pole D-SUB connector which
connects to the PC (use 25-9 pole adapter if necessary).
Connect the interface cable (art.no. 20913 or 21122) between PC and GPS. Select the
function REMOTE, then run the interface software (see instructions).
Contact your SILVA dealer for more information.
52
To Next Page
Loading...
