GPS NAVIGATOR
10 FAULT FINDING
Check:
- Sufficient battery voltage.
- Cables for damage.
- Faulty contact in connectors.
- Connector corrosion caused by poor protection.
- Short circuit on the NEXUS Network.
The following error messages can appear on the display:
Some errors are made by improper connections or when calling for unconnected
functions (missing transducers).
01 = Stack error.
02 = SILVA BUS missing, Check databus colours and connections.
03 = Watchdog Timout, Check the connections.
04 = EEPROM: Read-error.
Os = EEPROM: Write-error.
06 = RAM-MEMORY Read-error
07 = UART Queue-Pointer-error
OB = Break Point Reset
09 = EEPROM-Initialization
10 = Range-error caused by incorrect format, e.g. 17070 minutes East.
11 = Remote command that can not be performed (calibration-error)
12 = No response, or missing navigator unit
13 = WayPoint Not DEFined
14 = Oporation that can not be done with external NMEA navigator.
15 = Operation that can not be done in AUTO-Pilot Mode
16 = (notused)
17 = (notused)
18 = (notused)
19 = (notused)
20 = GPS -> CPU: Communication Error.
21 = GPS AQUISITION - failure (time out during indoor use).
22 = CPU -> GPS: Communication errori
23 = DGPS (RTCM) overrun
24 = Bad-Fix (1-Fix timout)
25 = (not used)
26 = (not used)
27 = Extended Object Server Error (set the GPS to Master)
28 = Route command error (bank, full..)
53
To Next Page
Loading...
