Nibe F370 Installer Manual

choose another file
update firmware7.1
Select “choose another file" if you do not want to use
the suggested software. When you scroll through the
files, information about the marked software is shown
in a fact box just as before. When you have selected a
file with the OK button you will return to the previous
page (menu 7.1) where you can choose to start the
update.
Menu 7.2 - logging
logging7.2
activated
interval
sec
5
Setting range: 1 s – 60 min
Factory setting range: 5 s
Here you can choose how current measurement values
from F370 should be saved onto a log file on the USB
memory.
1. Set the desired interval between loggings.
2. Tick “activated".
3. The present values from F370 are saved in a file in
the USB memory at the set interval until “activated"
is unticked.
NOTE
Untick "activated" before removing the USB
memory.
Menu 7.3 - manage settings
manage settings 7.3
save settings
recover settings
Here you can manage (save as or retrieve from) all the
menu settings (user and service menus) in F370 with
a USB memory.
Via "save settings" you save the menu settings to the
USB memory in order to restore them later or to copy
the settings to another F370.
NOTE
When you save the menu settings to the USB
memory you replace any previously saved set-
tings on the USB memory.
Via "recover settings" you reset all menu settings from
the USB memory.
NOTE
Reset of the menu settings from the USB
memory cannot be undone.
59Chapter 9 | ServiceNIBE™ F370

Nibe F370 Specifications

General

Type	Exhaust Air Heat Pump
Refrigerant	R290
Energy class	A++
Energy Efficiency Class (Space Heating, 35°C)	A++
Energy Efficiency Class (Space Heating, 55°C)	A+
Application	Residential
Hot Water Tank Volume	170 l
Heating Power	8.5 kW