Installation date
Manufacturing number
Set damper angle, outdoor air
Chosen output, immersion heater
Circulation pump setting
Fan rating
Selected fan curve
Set damper angle, exhaust air
Setting Heating curve selection
Setting Heating curve offset
General
FIGHTER 600P
For Home Owners
2
In order to get the ultimate benefit from your heat
pump FIGHTER 600P you should read through the
For Home Owners section in this Installation and
Maintenance Instruction.
FIGHTER 600P is a combined exhaust air and out-
door air heat pump. This means it utilises energy in
ventilation air and outdoor air when this does not
fall below -5 °C. This energy is used for hot water
and heating the house.
A microprocessor ensures that the heat pump
always works efficiently.
FIGHTER 600P uses R290 (Propane) environmental
heat transfer fluid.
Installation engineers
To be filled in when the heat pump has been
installed
Setting Blocking temperature immersion heater
Pre-pressure expansion vessel (0.5 bar on delivery)
To Next Page
Loading...
