Start-up and inspection
Start guide
NOTE
There must be water in the climate system
before the switch is set to "
".
1.
Set the indoor module switch (SF1) to mode "
".
2.
Follow the instructions in the start guide in the in-
door module display. If the start guide does not
start when you start the indoor module, start it
manually in menu 5.7.
TIP
See page 33 for a more in-depth introduction
to the installation’s control system (operation,
menus etc.).
Commissioning
The first time the installation is started a start guide is
started. The start guide instructions state what needs
to carried out at the first start together with a run
through of the installation’s basic settings.
The start guide ensures that the start-up is carried out
correctly and cannot be bypassed. The start guide can
be started later in menu 5.7.
During the start up guide the reversing valves and the
shunt valve are run backward and forwards to help
vent VVM 310.
Caution
As long as the start guide is active, no function
in the heat pump will start automatically.
The guide will appear at each heat pump re-
start until it is deselected on the last page.
Operation in the start guide
ODQJXDJH
,I WKH VWDUW JXLGH LV OHIW RQ WKLV SDJH LW FORVHV
DXWRPDWLFDOO\ LQ
PLQ
VWDUW JXLGH 1,%( 990
A. 3DJH
D. +HOS PHQXC. 2SWLRQ VHWWLQJ
B. 1DPH DQG PHQX QXPEHU
A. Page
Here you can see how far you have come in the start
guide.
Scroll between the pages of the start guide as follows:
1.
Turn the control knob until one of the arrows in
the top left corner (at the page number) has been
marked.
2.
Press the OK button to skip between the pages in
the start guide.
B. Name and menu number
Read what menu in the control system this page of the
start guide is based on. The digits in brackets refer to
the menu number in the control system.
If you want to read more about affected menus either
read off in the sub-menu or in the installation manual
from page 37.
C. Option / setting
Make settings for the system here.
D. Help menu
In many menus there is a symbol that indicates
that extra help is available.
To access the help text:
1.
Use the control knob to select the help symbol.
2.
Press the OK button.
The help text often consists of several windows that
you can scroll between using the control knob.
31Chapter 6 | Commissioning and adjustingNIBE™ VVM 310
To Next Page
Loading...
