Nibe VVM 310 - Menu 5 - SERVICE

Menu 5 - SERVICE
Overview
5.1.1 - hot water settings5.1 - operating settings5 - SERVICE
5.1.2 - max flow line temperat-
ure
5.1.3 - max diff flow line temp.
5.1.4 - alarm actions
5.1.10 - op. mod heat med
pump
5.1.11 - pump speed heating
medium
5.1.12 - internal electrical addi-
tion
5.1.14 - flow set. climate sys-
tem
5.1.18 - flow setting charge
pump
5.2.2 - installed slaves5.2 - system settings
5.2.4 - accessories
5.3.3 - extra climate system *5.3 - accessory settings
5.3.4 - solar heating *
5.3.7 - external addition
5.4 - soft in/outputs
5.5 - factory setting service
5.6 - forced control
5.7 - start guide
5.8 - quick start
5.9 - floor drying function
5.10 - change log
5.11.X.1 - heat pump5.11.1 - EB1015.11 - slave settings
5.11.X.2 - charge pump
* Accessory needed.
Hold the Back button in for 7 seconds to access the
Service menu.
Sub-menus
Menu SERVICE has orange text and is intended for
the advanced user. This menu has several sub-menus.
Status information for the relevant menu can be found
on the display to the right of the menus.
operating settings Operating settings for the indoor
module.
system settings System settings for the indoor module,
activating accessories etc.
accessory settings Operational settings for different
accessories.
soft in/outputs Setting software controlled in and
outputs on the input circuit board (AA3).
factory setting service Total reset of all settings (includ-
ing settings available to the user ) to default values.
forced control Forced control of the different compon-
ents in the indoor module.
start guide Manual start of the start guide which is
run the first time when the indoor module is started.
quick start Quick starting the compressor.
NOTE
Incorrect settings in the service menus can
damage the installation.
Menu 5.1 - operating settings
Operating settings can be made for the indoor module
in the sub menus.
NIBE™ VVM 310Chapter 8 | Control - Menus50