the compressor respectively additional heat will
start/stop.
Caution
Higher value on "start compressor" gives more
compressor starts, which increases wear in the
compressor. Too low value can give uneven
indoor temperatures.
Menu 4.9.4 - factory setting user
All settings that are available to the user (including
advanced menus) can be reset to default values here.
Caution
After factory setting, personal settings such as
heating curves must be reset.
Menu 4.9.5 - schedule blocking
The compressor and/or addition in the indoor module
can be scheduled to be blocked for up to two different
time periods here.
When scheduling is active the relevant blocking symbol
is shown in the main menu on the symbol for the in-
door module.
DFWLYDWHG
VFKHGXOH VFKHGXOH
DOO
PRQ
WXHV
ZH
WKXU
IUL
VDW
VXQ
VFKHGXOH EORFNLQJ
7LPH SHULRG %ORFNLQJ'D\
$FWLYDWHG
6FKHGXOH
&RQIOLFW
Schedule: The period to be changed is selected here.
Activated: Scheduling for the selected period is activ-
ated here. Set times are not affected at deactivation.
Day: Select which day or days of the week the schedule
is to apply to here. To remove the scheduling for a
particular day, the time for that day must be reset by
setting the start time to the same as the stop time. If
the line "all" is used, all days in the period are set for
these times.
Time period: The start and stop time for the selected
day for scheduling are selected here.
Blocking: The desired blocking is selected here.
Conflict: If two settings conflict with each other a red
exclamation mark is displayed.
Blocking the compressor in the outdoor unit.
Blocking additional heat.
TIP
If you wish to set similar scheduling for every
day of the week start by filling in “all” and then
changing the desired days.
Caution
If the stop time is before the start time it
means that the period extends past midnight.
Scheduling always starts on the date that the
start time is set for.
Caution
Long term blocking can cause reduced comfort
and operating economy.
49Chapter 8 | Control - MenusNIBE™ VVM 310
To Next Page
Loading...
