Nice 3501

13
8 - PARTS IDENTIFICATION
Control Box
#CBOX1050
Chassis
#CHBOX350
Arm Assembly
#ABOX350
9 - POST INSTALLATION
IMPORTANT - Never weld parts to the gate or posts when the operator circuit board is powered. Doing so may damage the board
beyond repair.
9.1 - Post location guide
Determine the angle that the gate will open to (A). Select the coordinates (B&C) as shown on the chart below. Distances are from the
hinges square to the center of the mounting post. Longer gates should operate at slower speeds.
E
C
B
D
A