16
Install the gate attach bracket to the adjustable arm using the
1/2” x 2-1/2” hex bolt, washers, and lock nut; or hitch pin.
Attach the secondary arm to the primary arm using a 1/2” x
2-1/4” hex bolt, brass washers and lock nut. The stop tab
should be positioned away from the gate.
Install the aluminum adjustable arm to the secondary arm
using the 1/2” x 1-1/2” hex bolt and nut. Use the middle hole
in the adjustable arm.
Note: Once limits are set and the board has been
programmed, this aluminum arm can be adusted to ne tune
the closed gate position.
11 - CONTROL ARM ASSEMBLY (CONT.)
12 - GATE BRACKET MOUNTING
Push the arm assembly up against the gate in the closed position.
Make sure that the primary arm is locked into the stop tab on the
secondary arm as shown below.
Tack weld or clamp the gate attach bracket to the gate.
Note: Permanent welds or bolt attachment should be completed
once limits are set.
Make sure that the primary arm
is locked into the stop tab on
the secondary arm.
To Next Page
Loading...
Need help?
General
