Nice RB500HS/V1 User Manual

28 – English
12
TECHNICAL SPECIFICATIONS
All technical specications stated herein refer to an ambient temperature of 20°C (± 5°C). • Nice S.p.A. reserves the right to modify its prod-
ucts at any time when deemed necessary, while nonetheless maintaining their intended use and functionality.
RB600 / RB600P RB1000 / RB1000P RB500HS RB500HS/V1
Product type Electromechanical gearmotor for the automatic movement of sliding gates for residential use, inclusive of
electronic control unit
Pinion Z15m4 Z15m4 Z18m4 Z18m4
Maximum frequency of operating
cycles (at nominal torque)
100 cycles / day
(the control unit limits
the cycles to the maxi-
mum value specied in
Table 2)
150 cycles / day
(the control unit limits
the cycles to the maxi-
mum value specied in
Table 2)
100 cycles / day
(the control unit
limits the cycles to
the maximum value
specied in Table 2)
100 cycles / day
(the control unit limits the cy-
cles to the maximum value
specied in Table 2)
Maximum continuous operating
time (at nominal torque)
7 minutes
(the control unit limits
continuous operation
to the maximum value
specied in Table 2)
5 minutes
(the control unit limits
continuous operation
to the maximum value
specied in Table 2)
6 minutes
(the control unit limits
continuous operation
to the maximum value
specied in Table 2)
6 minutes
(the control unit limits
continuous operation to the
maximum value specied in
Table 2)
Application limits ROBUS is generally able to automate gates up to the weight and length limits specied in Table 1
Durability Estimated between 20,000 and 250,000 cycles, depending on the conditions given in Table 2
Power supply
Version V1
230V
(+10% -15%) 50/60Hz
120V
50/60 Hz
Maximum power input at peak
[corresponding to amperes]
515 W [2.5 A]
[4.8 A version /V1]
450 W [2.3 A]
[4.4 A version /V1]
460 W [2.5 A]
[4.8 A version /V1]
460 W [2.5 A]
[4.2 A version /V1]
Insulation class 1 (a safety earthing system is required)
Emergency power supply With PS124 optional accessory
Flashing light output For 2 x LUCYB ashing lights or similar (12 V, 21 W lamp)
Gate Open Indicator (G.O.I.)
output
For one 24 V maximum 4 W lamp (the output voltage may vary between –30 and +50% and can also
control small relays)
BLUEBUS output One output with maximum load of 15 BLUEBUS units
STOP input For normally closed or normally open contacts or for 8.2 kΩ constant resistance with self-recognition
(any variation from the memorised status triggers the “STOP” command)
Step-by-step input For normally open contacts (closing of the contact triggers the STEP-BY-STEP command)
OPEN input For normally open contacts (closing of the contact triggers the OPEN command)
CLOSE input For normally open contacts (closing of the contact triggers the CLOSE command)
Radio connector SM connector for SMXI and OXI receivers
Radio ANTENNA Input 52 Ω for RG58 or similar type cable
Programmable functions 8 ON-OFF functions and 8 adjustable functions (see Tables 5 and 7)
Self-recognition functions Automatic recognition of devices connected to the BLUEBUS output
Self-recognition of the type of “STOP” device (Normally Open, Normally Closed contact or 8.2 kΩ resistor)
Self-recognition of the gate length and calculation of the deceleration points and partial opening points

Nice RB500HS/V1 Specifications

General

Brand	Nice
Model	RB500HS/V1
Category	Gate Opener
Language	English