Summary
Chapter 1 P. 5
Chapter 2 P. 7
Chapter 3 P. 12
Chapter 4 P. 15
Chapter 5 P. 21
Chapter 6 P. 29
Chapter 7 P. 31
Chapter 8 P. 42
XXXXXXXXXX
4
General information
Important safety information
General Information and Ratings
Mechanical Installation
Operation
Parameters
Analog and Digital Input Macro
Configurations
Power Wiring
Chapter 9 P. 48
Chapter 10 P. 50
Modbus RTU Communications
Technical Data
Trouble Shooting
Chapter 11 P. 54
AD700E
2 Important Safety Information 2.1 Quick Start Up
2.2 Quick Start Process
Quick Start – IP20 & IP66 Non Switched
Quick Start – IP66 Switched
3 General Information and Ratings 3.1 Identifying the Drive by Model Number 3.2 Drive Model Numbers
1 General information 1.1 Electromagnetic Compatibility
4 Mechanical Installation
4.1 General
4.2 UL Compliant Installation
4.3 Mechanical Dimensions and Mounting –
IP20 Open Units
4.4 Guidelines for Enclosure Mounting –
IP20 Units
4.5 Mechanical Dimensions – IP66 (Nema 4X)
Enclosed Units
4.6 Guidelines for mounting (IP66 Units)
4.7 Gland Plate and Lock Off
4.8 Removing the Terminal Cover
4.9 Routine Maintenance
6 Operation
6.1 Managing the Keypad
6.2 Changing Parameters
6.3 Read only parameter access
6.4 Resetting parameters
6.5 Resetting a fault
5 Power Wiring
5.1 Grounding the Drive
5.2 EMC Filter Disconnect
5.3 Wiring Precautions
5.4 Incoming Power Connection
5.5 Drive and Motor Connection
5.6 Motor Terminal Box Connections
5.7 Motor Thermal overload Protection
5.7.1 Internal Thermal Overload Protection
5.7.2 Motor Thermistor Connection
5.8 Control Terminal Wiring
5.9 Connection Diagram
5.9.1 IP66 (Nema 4X) Switched Units
5.9.2 IP20 & IP66 (Nema 4X)
Non- Switched Units
5.10 Using the REV/0/FWD Selector Switch
(Switched Version Only)
5.11 Control Terminal Connections
7 Parameters 7.1 Standard Parameters
7.2 Extended Parameters
7.3 Advanced Parameters
7.4 P-00 Read Only Status Parameters
8 Analog and Digital Input Macro
Configurations
8.1 Overview
8.2 Macro Functions Guide Key
8.3 Macro Functions – Terminal Mode
(P-12 = 0)
8.4 Macro Functions - Keypad Mode
(P-12 = 1 or 2)
8.5 Macro Functions - Fieldbus Control Mode
(P-12 = 3, 4, 7, 8 or 9)
8.6 Macro Functions - User PI Control Mode
(P-12 = 5 or 6)
8.7 Fire Mode
8.8 Example Connection Diagrams
9 Modbus RTU Communications
9.1 Introduction
9.2 Modbus RTU Specification
9.3 RJ45 Connector Configuration
9.4 Modbus Telegram Structure
9.5 Modbus Register Map
10 Technical Data 10.1 Environmental 10.2 Rating Tables 10.3 Additional Information for UL Compliance
11 Trouble Shooting 11.1 Fault Code Messages
SUMMARY
To Next Page
Loading...
Need help?
General