Nidec COMMANDER S100 - Page 47

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Running the
motor
Drive parameters Communications Diagnostics Technical data
UL Listing
Information
Commander S100 User Guide 47
P0.05 = 4 Presets (4)
Switch between four preset speeds using digital input 1 and digital input 5.
P0.05 = Keypad (5)
In Status mode use the UP and DOWN buttons on the keypad to increase or decrease the Up/Down Percentage (P1.18) which defines the
frequency reference, where 0 % = Minimum Frequency Limit (P0.01); and 100 % = Maximum Frequency Limit (P0.02). This setting does not change
the Run and Stop commands. See section 6.3 Running, stopping and controlling motor direction.
No changes are made to the I/O for this setting.
Preset Frequency 2
(P2.17)
Preset Frequency 3
(P2.18)
Preset Frequency 4
(P2.19)
Preset Frequency 1
(P2.16)
Reference 1
Reference 2
Reference 3
Reference 4
T9
T11
T15
Reference 1 Reference 2 Reference 3
Reference 4
0
1
01
0
0
1
1
1
2
3
4
9
+10 V Output
0 V
5
0 V
6
Analog output
10
11
12
13
14
15
+24 V Output
0 V
DI 2
DI 3
DI 4
Presets (P0.05 = 4)
Ref Select 0 (DI 5)
Analog input 1 (AI1)
Ref Select 1 (DIO 1)
Analog input 2 (AI2)
Not Configured
Not Configured
Not Configured
Up/Down
Percentage (P1.18)
Reference 1
Reference 2
Reference 3
Reference 4