Nidec COMMANDER S100 - Page 64

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting started
Running the
motor
Drive
parameters
Communications Diagnostics Technical data
UL Listing
Information
64 Commander S100 User Guide
P1.24 DC Bus Voltage
Range: 0 to Maximum D.C. Bus Voltage V Default: Read Only
Displays the voltage on the D.C. Bus of the drive.
This voltage must exceed the under-voltage (UV) level for the drive to run.
P1.25 Digital IO Indicators
Range:
0
7
0
6
0
5
0
4
0
3
0
2
0
1
0
0
to 1
7
1
6
1
5
1
4
1
3
1
2
1
1
1
0
Default: Read Only
Displays a set of indicators that represent the status of all the digital inputs and outputs as well as the digital status of the analog inputs.
P1.26 Parameter 1 Saved Value on Error
P1.27 Parameter 2 Saved Value on Error
P1.28 Parameter 3 Saved Value on Error
Range: Dependent on Parameter Saved Default: Read Only
If an error occurs the drive will save the value of the parameter selected by Parameter 1 Save on Error Selector (P4.09), Parameter 2 Save on
Error Selector (P4.10), and Parameter 3 Save on Error Selector (P4.11).
All of these parameters are saved at the point when Error (P1.29) occurs.
P1.29 Error
P1.30 Error History 1
P1.31 Error History 2
P1.32 Error History 3
Range: 0 to 255 Default:
Displays the most recent error (including an active error). Previous errors are listed with Error History 1 being more recent than Error History 3.
Drive Rated Voltage Under Voltage Level Maximum D.C. Bus Voltage
100 V 175 V 415 V
200 V 175 V 415 V
400 V 330 V 830 V
Bit Input/Output Description
Bit 0 T11 Digital IO 1 Set to 1 if the input or output is active
Bit 1 T12 Digital Input 2 Set to 1 if the input is active
Bit 2 T13 Digital Input 3 Set to 1 if the input is active
Bit 3 T14 Digital Input 4 Set to 1 if the input is active
Bit 4 T15 Digital Input 5 Set to 1 if the input is active when T15 Digital Input 5 Type (P6.05) = 0 (Digital Input)
Bit 5 T2 Analog Input 1 Set to 1 if the input is active when T2 Analog Input 1 Type (P6.01) = 1 (Digital)
Bit 6 T4 Analog Input 2 Set to 1 if the input is active when T4 Analog Input 2 Type (P6.02) = 1 (Digital)
Bit 7 T41 Relay Set to 1 if the relay is active