Nidec Digitax HD M751 Base - Page 25

Safety information Product information Mechanical installation Electrical installation Multi axis system design Technical data
Digitax HD M75X Series Installation and Technical Guide 25
Issue Number: 5
Figure 3-11 Frame 3 dimensions
* Cut outs only required for rear venting; refer to section 3.9 Rear venting on page 28.
Mounting screws
For single axis drives stand alone, two M5 screws are required in the top mounting position and one in the lower mounting position.
For multi axis drive mounting, refer to section 5.7 Multi axis system installation on page 92.
40 mm
(1.58 in)
174 mm (6.85 in)
328 mm (12.91 in)
12 mm
(0.47 in)
Æ 5.2 mm
(0.21 in)
28 mm
(1.10 in)
35 mm
(1.38 in)
Æ32 mm
(1.26 in)
*
317 mm (12.48 in)
5 mm
(0.20 in)
6 mm
(0.24 in)
Æ 5.2 mm
(0.21 in)
40 mm (1.58 in)