Safety information Product information Mechanical installation Electrical installation Multi axis system design Technical data
Digitax HD M75X Series Installation and Technical Guide 43
Issue Number: 5
3.18 Fan replacement
Figure 3-28 Removal of frame size 1 and 2 cooling fan
1. Using a flat bladed tool, press the two tabs inwards to release the fan from the drive frame.
2. Partly withdraw the fan assembly and prise out the two way fan plug from the connector. This should not be performed by pulling on the fan supply
cable. Fully withdraw the fan from the housing.
Accumulations of dust on the drive or fan assembly should be removed by vacuuming.
Electric shock risk
The AC and DC power supply must be disconnected from the drive using an approved isolation device before the fan assembly is removed.
To Next Page
Loading...
