Safety information Product information Mechanical installation Electrical installation Multi axis system design Technical data
Digitax HD M75X Series Installation and Technical Guide 23
Issue Number: 5
3.6 Drive dimensions
The drive complies with the requirements of IP20.
The product is designed to fit within a 200 mm (7.87 in) deep cabinet, this may require the use of an angled feedback connector.
3.6.1 Drive dimensions
Figure 3-9 Frame 1 dimensions
* Cut out only required for rear venting; refer to section 3.9 Rear venting on page 28.
Enclosure
The drive is intended to be mounted in an enclosure which prevents access except by trained and authorized personnel, and which
prevents the ingress of contamination. It is designed for use in an environment classified as pollution degree 2 in accordance with
IEC 60664-1. This means that only dry, non-conducting contamination is acceptable.
40 mm
(1.58 in)
174 mm (6.85 in)
12 mm
(0.47 in)
Æ 5.2 mm
(0.21 in)
28 mm
(1.10 in)
Æ32 mm
(1.26 in)
*
5 mm
(0.20 in)
233 mm (9.17 in)
222 mm (8.74 in)
40 mm (1.58 in)
6 mm
(0.24 in)
Æ 5.2 mm
(0.21 in)
Æ 5.2 mm
(0.21 in)
To Next Page
Loading...
